Certance DLT 1 Guía de usuario descargar pdf (Pagina 17)

Installing a DLT, SDLT, VS, LTO, or DAT Tape Drive Into a Linux Operating System

6464215-01, Rev B

January 2006

mt-st Linux RPM Package 17

mt-st Linux RPM Package 0

The mt-st Linux Red Hat Package Manager (RPM) package consists of the

following tools:

•

mt tape device manager (see mtx Tape Library Tool on page 20)

•

stinit tape configuration utility (see mt Tape Device Tool)

In order to use the package, you must ensure that

mt-st is installed. See the

following chapters:

• Verifying mt-st is Installed

and

• Installing mt-st

Verifying mt-st is

Installed

To perform the actions described from this point forward in this guide, you

must ensure

mt-st is installed.

To check whether

mt-st is installed, execute the following command:

# rpm -qa | grep mt-st

This command returns the name of the package followed by a version

number (for example, RHEL3 returns

mt-st-0.7-11).

If no information is returned,

mt-st is not installed on your system. To install

mt-st, see Installing mt-st.

Installing mt-st 0 mt-st is usually included on your Linux installation CD-ROM.

To install

mt-st, execute the following command:

# rpm -ivh mt-st*

where the asterisk represents the remaining portion of the file name (in this

case, it is the version number).

mt Tape Device Tool 0

mt is a tape device management tool that enables you to set st driver flags,

position loaded media, and secure-erase media.

mt-st is installed, then mt is available for use. See Verifying mt-st is Installed

for instructions on checking whether

mt-st is installed.

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 31 32

Comentarios a estos manuales

Sin comentarios

Certance DLT 1 Guía de usuario Pagina 17

Comentarios a estos manuales

Relacionado con productos y manuales para Las unidades de cinta Certance DLT 1